Bluesky
Peter Pak
@ppak.net
Just presented my thesis proposal Continuous Learning Enabled Agentic Additive Manufacturing today!
0
0
0
4d ago
Bluesky
Peter Pak
@ppak.net
Going to print out the brackets and print bed with SLS. First print where I'm gonna pack the build chamber with parts.
0
1
0
Peter Pak
@ppak.net
Around 230ish layers
0
1
0
Peter Pak
@ppak.net
Layer 7, 8, and 9
0
1
0
Peter Pak
@ppak.net
Layer 141, 142, 143, and 144
0
1
0
Peter Pak
@ppak.net
Print successful and deporting using SLS4All’s Easy Post Processing station
0
1
0
Peter Pak
@ppak.net
Post processed parts and initial assembly
0
1
0
Peter Pak
@ppak.net
Finished Trophy
0
1
0
Peter Pak
@ppak.net
0
0
0
Bluesky
Peter Pak
@ppak.net
Working on Yayati's Trophy for his defense this Friday, here's the assembly I'm planning on working from. #trophy
0
1
0
Bluesky
Peter Pak
@ppak.net
Contour op took a big chunk out before knocking the stock off the fixture plate.
0
1
0
Peter Pak
@ppak.net
This is probably due to the fact that I forgot about the x and y offsets from the origin when making the mastercam file
0
1
0
Peter Pak
@ppak.net
Also used 3/4” 6-32 screws with some nuts and washer to hold in the part better. Previously was using 1/2” and those didn’t seem to hold the stock to the fixture well enough
0
1
0
Peter Pak
@ppak.net
Contours seems to be going well
0
1
0
Peter Pak
@ppak.net
Seems that towards the end of the contour ops the screws holding the part in place broke.
0
1
0
Peter Pak
@ppak.net
Trying contour ops again now with just taking off 0.025”
0
1
0
Peter Pak
@ppak.net
Also change the 3/8” tool from high speed steel to my own carbide tool
0
1
0
Peter Pak
@ppak.net
Facing op
0
1
0
Peter Pak
@ppak.net
Finished run, though engraving tool was a bit too deep
0
1
0
Peter Pak
@ppak.net
Finished trophies!
0
0
0